多机种模拟器MESS&MESSUI 0.146u5发布
http://bbs.emu618.com/data/attachment/forum/201111/15/193413ybu36d8g6udo6ogg.jpghttp://pic90.picturetrail.com/VOL2350/11793858/21120340/350251901.jpghttp://pic90.picturetrail.com/VOL2350/11793858/21120340/350251908.jpg
多机种模拟器MESS发布新版，更新如下：
Systems Promoted from GAME_NOT_WORKING:
---------------------------------------
- SBC6510
Skeleton drivers:
-----------------
- VAX 785 (LSI-11 board only)
- Elektronika MS-0515
System Driver Changes:
----------------------
-llc1: fixed monitor keyboard LLC2: added speaker and annoying keyclick
-vidbrain: Added expansion port interface.
-vidbrain: Added expansion port pinout. (nw)
-llc: modernised ; LLC2 added support for reverse video & added missing pio.
-vk100: Some improvement to the HLE vector generator, now properly emulates the down counter so the "blue screen" part of the POST looks correct, as does the cursor width.
-vk100: broke the vram access logic/math out of the vector generator callback and into its own functions; fixed? the systat_a register to read the vram nybble the x and y regs are currently pointing to.
-abc800c: Added character display, promoted driver to working.
-pcm: connected the k7659 keyboard, fixed screen size
-abc800c: Added high resolution graphics.
-abc80: Added serial interface.
-a6809: Added ASCII keyboard.
-abc806: Used correct HRUII PROM.
-socrates: document that an MCU dump is missing of the 4-bit TMP42C40P that decodes the IR signal from the keyboard and buffers the 'second stage' of the keyboard input. Changed code slightly to reflect this.
-z9001 : added 2xpio, ctc, daisy-chain, beeper-sound, cassout
-v6809 : various video improvements.
-abc80: Refactored legacy code, moved DOS ROMs to ABC bus DOS card, added BASIC V1 dump, added ABC 890 bus expander device.
-abc80x: Refactored legacy code, cleaned up keyboard interface, added ABC894 bus expander device, added ABC 55 keyboard for ABC 802.
-vt100: add the GPO (aka VT125 mono board) roms and proms as a mix of NO_DUMP and copies of the vk100 ones where identical
-vk100: further comment updates, got rid of LASTVRAM in favor of doing a single read at the current nybble pointed to by the X and Y registers.
-vk100: Implemented baud generator LUT for i8251, not hooked up yet; added RTS callback which doesn't seem to work yet.
-vk100: Doing further vector rom tracing with a meter on the board using the vt125 schematics as a guide, figured out what all the vector rom pins do (except perhaps D LOAD).
-vip: Added VP-620 ASCII keyboard cable, VP-570 RAM expansion board, and VP-575 bus expander board.
-plus4: Rewrite of the C16/Plus+4 driver with improved memory mapping and cartridge support. Refactored the Commodore 1551 floppy drive to connect to the expansion port.
-vk100: Documented all the inputs and enables of the RAS/ERASE prom through tracing. Documented that the MSB bit of the SYNC prom is ... SYNC. The VT125 Schematics were invaluable for this.
-sbc6510: Connected up the keyboard and added ay-3-8910 chip
-vii: Fixing some warnings. Not 100% sure of the intended functionality, but IRQ & IRQ_MASK & line seems probable and seems to work.
-c64: Fixed C1541 and FSD-2, added Dolphin DOS 2.0 and Professional-DOS V1 hardware.
-plus4: Added SID card emulation.
-c64: Emulated the digital read circuitry of the Commodore 1541 disk drive according to the long board schematics. This will allow independent setting of the bitrate of incoming data and the sample rate. Passing more advanced copy protections require a cycle exact rewrite of the 6502 and VIA, but this is the first step toward proper emulation.
-vip: Added VP-700 Tiny BASIC board.
-c64: Added support for per-byte speed zones in G64 images.
-sacstate: Added comments. Fixed input ports.
-hr16: Hooked up LCD controller and added keypad inputs.
-rainbow:
* Get closer to LK201 emulation
* Add documentation for system error codes and diagnostic LEDs
-vboy: various driver improvements
-vboy: preliminary audio hookup
-x1: added support for old TAP format to the driver, so that all newly added tapes work (high sample rate tapes are still not supported, though)
Software Lists:
----------------
-pico.xml: added new Jpn dumps
-pico.xml: started documenting PCBs and ROM labels
-x1_flop: first round of new dumps
-x1_cass: some more new dumps
Source Changes:
----------------
-new device k7659 keyboard; modified LLC2 to work with it
-k7659kb - added more keys, added port_char, added return value when no key pressed
-terminal: Replaced internal keyboard with the Ascii keyboard, since they were identical.
-nscsi: documentation
-rp5c15: Initialize at power-on (makes the x68k boot reliable)
-roc10935/7: correct an error in the lookup table for the '7' character
http://www.mess.org/
http://messui.the-chronicles.org/ 这个模拟器真不错，刚刚用过。。。。。。
页:
[1]